In the process of production, the final result is that many customers pay more attention to it. This is mainly related to the method used in the whole process. This molding process must be operated step by step according to the correct steps, so as to produce a conformity. The product requested by the customer.

Silicone button forming process:
1. Prepare the upper mold first, clean the oil stain on the machine and the mold, check the operation standard book and sample, whether the mold has rusty spots, if there is a need to spray sand, change the mold pad, the water tank seal should pay attention to the temperature adjustment The temperature on the craft book is the same as the preparation.

2. After about 20 minutes, test with a thermometer, whether it is consistent with the craft book, and then clean it with the washing material. After pressing it out, check whether there are pinholes and winds.

3, c type to do the first piece, the size requirements and load on the craft book in the two points before the formal die pressing, can be produced after confirmation. The operator checks 100% of the product and finds that the defective product needs to be picked out, placed in the defective product area, and the bad problem is improved. The sampler will conduct a random inspection of the product every 2 hours. Early detection of bad to reduce the rate of non-performing.

When the silicone button is formed, the background color should be transparent. Then, the surface of the silicone button is screen printed with red silk or directly sprayed with red ink. At this time, the concentration of the red ink should be low, or the thickness of the silk screen spray should be thin to facilitate light transmission. Then, the surface of the silk screen or the red ink is sprayed with a black ink process, and finally the laser beam is used to engrave the surface of the silicone button, so that the black ink of the water tank seal is peeled off and the red bottom is exposed, and then it can be seen. The red character is gone.