Silicone products always encounter a lot of conditions in the production process: such as cracking, yellowing, black spots, odor and so on. And there will be similar situations during use, which will have a negative impact on normal use, so find out the specific reasons and analyze and solve them to make customers feel more at ease.

Silicone product problems:
1. The phenomenon of oiling
Silicone products custom manufacturers introduced sometimes in some mobile phone cases, silicone bracelets, daily necessities, raw materials, more comprehensive products, there will be oily phenomenon, so that the product is smooth and sticky, because the raw materials infiltrated silicone oil and white mine A mixture of oils can cause oil to collide with silica.

2, yellowing
Silicone product problem: yellowing is the essence of ordinary silicone products. Generally, after the use of the product for a long time, the yellowing phenomenon will occur after the environmental changes, but the addition of anti-yellowing agent can achieve the phenomenon of non-yellowing, using food grade silicone raw materials. With the gas phase method of silica gel raw material, the high transparent high tensile high quality silica material body will not appear yellow.

3, the pull is too bad
Sometimes the silicone products purchased have poor pull strength, and the rebound force is small or even broken. This phenomenon can be found from the silicone product manufacturers. The reason can also be found from the raw materials. In the raw materials, the suppliers add too much. The amino-modified silicone oil is added with acid white clay as a catalyst, so the viscosity of the silica gel raw material is improved, and the tear resistance and the elongation of the raw materials of different hardnesses cause a decrease in the life of the product.

Silicone products custom manufacturers introduced sometimes there will be sticky glue, the surface of the product has a separable rubber layer. Cause: The mold is not cleaned properly or mixed with vulcanized rubber fly skin during rubber mixing, the pressure is insufficient, and the skeleton at the table is parked for too long.